- per page
Nut Steering Stem Upper (AL6061 Aluminium 36xM27x1.0 Hard anodised gloss silver)
2 Required (one is used as lock nut)
Heavy duty rod kit built to OE specs. No chinese junk here. Made in Taiwan.
Brake Pedal Billet Alloy Maico 76-77 Ball bearing pivot and Stainless Steel detachable serrated toe section.
New *** Improved design ***
Heavy duty rod kit built to OE specs. No chinese junk here. Made in Taiwan.
Brake Pedal Billet Alloy Maico 78-79 Ball bearing pivot and Stainless Steel detachable serrated toe section.
New *** Improved design***
Maico Foot Pegs 81-86 (pair), Updated ergonomic design, Manufactured using #304 Stainless Steel Alloy, 55mm wide with raised arch for maximum boot contact, Precision Laser cut with CNC machined mounting Fully TIG welded, fits original mounts using original Springs and Bushings.
The ultimate footpeg for for these models
Application: Maico '81-86
Special Note: The Mounting boss for these footpegs has been precision CNC machined to original Maico specifications, please remember these bikes are now 38+ years old and there will be differing amounts of wear detected on the frame stopper dependent on the bikes history, for the correct positioning of the footpeg most frames will need a small amount of correctional repair.
New Billet front lower brake lever, 10 mm longer than standard, Stainless Steel cable mount and pin, for increased leverage and improved braking performance. Precision CNC machined from 6061 aluminium alloy.
Direct replacement for 1980-on will fit other models
Brake Stay Front with cable clamp Maico 80-84 Drum Brake and Left side conversions
Bushing Foot Peg Pivot Bolt, Maico '75-78 Stainless Steel (Pair)
Maico Clevis Pin for Front Brake Lower Arm and Billet Rear Brake Pedal
Ignition Flywheel Puller 27mm x 1.25 RH Male Thread Motoplat Ignition Maico.
Also fits STK113 and STK 113L
Spacer Rear Wheel bearing to swingarm Maico 68-74 Steel Rear Hub left side
A great replacement part. Manufactured by Maico at Chippys.
Clutch Guide Nut Maico '68-82. Maico updated the design of these nuts several times over the years, this is the most recent, retrofits back to '68 for enhanced clutch operation
A great replacement part. Manufactured by Maico at Chippys.
O-Ring Shift Shaft Sealing Maico to '77
A great replacement part. Manufactured by Maico at Chippys.
Oil Filler Plug Maico '68-77, 19mm Hex, M20x1.5. CNC Alloy.
A great replacement part. Manufactured by Maico at Chippys.
Front Brake Stay with Built In cable clamp, Maico '68-79. Right side brake.
Fork Dust Wiper Maico '76 38mm Short with Integral Seal (pair)
38mm (38x50x10.5) Double Lip (pair)
37.8 x 48 x 6
- per page
