Home :: 1975/1976 Yamaha DT 400 Intake Manifold

1975/1976 Yamaha DT 400 Intake Manifold

1975/1976 Yamaha DT 400 Intake Manifold

Manufactured by Hot Foot Moto LLC. Intakes are made from a polyurethane material that is very durable and has some stretch to it. Air boots and intake manifolds are molded from the same material. The intake manifolds will typically last 5 years on water cooled bikes, sometimes even longer. We recommend replacing intakes at the end of every race season on air cooled bikes. The air cooled bikes run much hotter than newer models. The hotter that an engine gets, the harder it is on the intake glue that is used.

If you notice an air leak, shut your bike down immediately. HFM will send a replacement for free. You do have to ship the intake back to HFM for inspection. If you are using a pod filter, the air filter needs to have some type of support. Without any support, the carburetor and pod filter bounce up and down while you are riding the bike. This will cause an intake manifold failure.

You must use a M6 socket head allen bolt for installation if the intake has polyurethane around the mounting holes. Larger hex head bolts will cut into the material.

SKU 01-0500
Weight 0.50 lbs
Our price: $109.95
Add to wish list
: *
: *
: *
1984 Honda CR 500 DG National MX Pipe
1979/1980 Kawasaki KDX 250 400 Side Panels Green
1980-1982 Kawasaki KDX 175; 1981 KDX 250 & 420; 1982 KDX 450 Side Panels Green
Mikuni 34mm TM Flat Slide Carburetor
Montesa VR Seat Foam
1986-1988 Kawasaki KDX 200 KDX200 Swingarm Bearing Kit
1978-1980 Honda CR 250 Seat Cover
1983 Yamaha IT 250 DG National MX Pipe
1981 1982 Yamaha YZ 80 ; 82/83 YZ 60 Clamp On Twin Air Filter